Compliance and Applications
FAA Compliant: AC 150/5345-46D L-852A, L-852C
ICAO: Annex 14, figs 1.1, 2.13, 2.14, 2.15, 2.16 & 2.17
NATO: STANAG 3316 (Para 22b, Annex C)
CAA: CAP168, figs 6A/12, 6A/13, 6A/14, 6A/15, 6A/16 & table 6A/1
BS3224: Part 5 inset fittings
Our ZA280 LED fixtures are suitable for use as inset taxiway centerline and stop-bar lights.
• Body casting manufactured from aluminum alloy for lightness, strength and durability.
• Corrosion resistant anodized finish.
• Prism removal and replacement achieved without the need for adhesive or sealants.
• Color variations achieved by using color specific LEDs.
• A window blank is available for unidirectional applications.
• Pre-focused optics to simplify maintenance procedures.
• Low profile .39" (10mm).
• Light channel within .2" (5mm) of grade.
• A power converter is supplied in the secondary cable between the isolation transformer and fixture.
• The power converter will control the LED's light output through 3 stages of brilliancy.
Suitable for use in 6.6A airfield lighting circuits normally supplied from 1 x 45W, 1 x 65W or 100W isolation transformer. Power consumption is 10W.
Net weight: 6.6 lbs. (3kg)
Gross weight: 7.7 lbs. (3.5kg)
Carton size: 9.06" [230mm(w)] x 9.06" [230mm(d)] x 5.75" [146mm(h)]
TYPE: Green/yellow/red, bidirectional, taxiway and stop bar light for centerline straight and offset sections.
The taxiway/stop bar bidirectional inset light shall comply with FAA, ICAO Annex 14 for use in category I, II and III all weather operations, CAP168, BS3224 Part 5, and STANAG 3316.
TYPE: Green/yellow/red, bidirectional, taxiway and stop bar light for centerline curve sections.
The taxiway/stop bar bidirectional inset light shall comply with ICAO Annex 14 for use in category I, II and III all weather operations, CAP168, BS3224 Part 5, FAA and STANAG 3316.
Fixtures shall be of modular design with the main casting manufactured in aluminum alloy, suitably protected against corrosion and with anodized finish.
The optical system shall comprise of a 3 LED segment for unidirectional applications, and a LED segment for bidirectional use. Two glass prisms shall be accurately located in the main casting, without the need for additional adhesives or sealants, to direct the light beams such that no re-focusing is required on installation, maintenance or in service. Color specific LEDs will be used to provide, green, yellow or red light. The fixtures shall be versatile so that requirements for both narrow and wide light distribution are met. Unidirectional applications shall be satisfied by the provision of a window blank.
Replacement of the LEDs is not envisaged until they have been in use for a nominal 80,000 hours, but when this is necessary replacement will be easily effected from the bottom of the fixture.
The light fixture shall have an upper surface forming a smooth sloped face projecting not more than .39" (10mm). above the pavement surface. The fixture shall resist all stresses imposed by impact, rollover and static loads of present day aircraft without damage to the fixture or to aircraft and vehicle tires.
A handbook shall be provided giving full installation, operation and maintenance instructions together with a detailed parts list.